Installing a Glacier Bay Aragon Tub and Shower
Installing a Glacier Bay Aragon tub and shower can be a daunting task, but with the right tools and instructions, it can be done in no time. Here are the steps to follow for a successful installation.
Step 1: Prepare the Area
Before you begin installing your new tub and shower, make sure that the area is properly prepared. This includes removing any existing fixtures, such as an old bathtub or shower, and ensuring that the walls are level and free of debris. You should also check to make sure that all necessary plumbing connections are in place.
Step 2: Install the Tub
Once the area is ready, you can begin installing the tub. Start by placing the tub on its side and securing it to the wall studs with screws. Make sure that the screws are long enough to penetrate through both sides of the wall studs. Once secured, use caulk to seal any gaps between the tub and wall.
Step 3: Install the Shower
Next, install the shower base onto the floor using construction adhesive. Make sure that it is level before securing it with screws. Then, attach the shower walls to the base using silicone caulk. Finally, connect all of the plumbing components according to manufacturer instructions.
Step 4: Finish Up
Once all of the components have been installed, you can finish up by adding any additional accessories such as grab bars or shelves. Finally, apply grout around all of the joints and seal them with silicone caulk. Your new Glacier Bay Aragon tub and shower is now ready for use!